OD Grinder Trailer

Model Number ODGT: OD Grinder Trailer for the removal of Hardbanding on Drill Pipe Tool Joint

Model ODG:

  • All steel skid fabrication Approximately 6’ Long x 4’ Wide x 6’ High Collapsed with open operator area.
  • Unit weighs approximately 3,300#.
  • Unit has four each Hydraulic powered drum rollers to rotate from 3 ½” O.D. pipe to 10” O.D. Pipe. As well as center wear pad on Hevi Wate Drill Pipe.
  • Drum Rollers are 6” O.D. x 8” Long. Two below pipe and two above pipe, lowered hydraulically.
  • Hydraulic conveying system to move pipe in/out, mounted on moveable exterior jack.
  • Two exterior jacks with 750lbs ball transfer rollers.
  • One jack is used with hydraulic conveying system to move pipe from racks to and from machine.
  • The other jack is used behind machine for center wear pad on Hevi Wate Drill Pipe.
  • All Hydraulic jack cylinders have 13” stroke with adjustable legs.
  • Hydraulic tank is 35 gallons, 6 gpm @ 1000 psi.
  • Grinder: 14” O.D. Grinding Wheel moves in axes “Z”, 14” and moves in axes “X”, 12”.
  • Grinding wheel tilts hydraulically for grinding the 18degree taper on drill pipe.
  • Unit is engine over hydraulic powered.
  • Unit will be powered by a 35HP vanguard electric start gas engine driving the hydraulic pump assembly.
  • Gas tank capacity is 31 gallons and mounted at the front of tongue area.
  • All controls are at operator’s finger tips.
  • Painted battle ship grey.

 

Installed in Trailer:

  • 14’ long cargo box, 19’ of total length.
  • Trailer Total Weight is 8,320 lbs.
  • Two each 7,000lbs axles with electric brakes.
  • 320 lbs. of tongue weight
  • One each 2 3/16” bumper pull hitch.
  • Five each ST235/80R 16” load range E tires on steel wheels.
  • One each tongue jack, heavy duty 8,000lbs drop leg jack.
  • All LED lighting system as per DOT.
  • Two each rear corner pin-able drop legs.
  • Two each 18” x 16” top hinge side doors to convey pipe in and out of grinder, one each side.
  • Two each side hinged rear doors with cam lock.
  • Two each side entry doors (rider’s side/driver’s side) to enter engine room. 78” x 36” wide.
  • Operator area entry door located in mid wall between operator area and engine room area.
  • Floor 1/8” steal diamond deck, full length and width.
  • LED lighting system for operator area, engine room area and external work lights mounted above pipe entry area.
  • Trailer will have a 2” thick wall that separates operator and grinder area from engine room.
  • Interior will be fully insulated and white aluminum.
  • Operator area will have work and exterior light controls as well.
  • Two each 22” x 40” tinted windows, one each side in operator area.
  • Operator area will have two each covered roof vents.
  • Operator will be seated inside, out of weather to operate machine.